Installation manual

Section 6 F Upgrading Software on Client-Only Systems
82
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
Step 7: Move the cursor to PROCEED WITH INSTALLATION and
press Return to continue the upgrade.
If there are no erro rs, the upgrade continues to completion.
During upgrade, the following display appears:
start of inst_upg_sybase.com
Deleting existing sybase files...
Installing SYBASE files...
Sybase install completed successfully on 12-DEC-1997 17:43.45
This completes the SYBASE Upgrade. See subsection 6.2 to upgrade
ENVOX software on a client-only system.
6.2 Upgrading ENVOX Software on Client- Only Systems
To upgrade ENVOX software:
Step 1: If you are not logged into the system manager’s account, log
in by entering the user name SYSTEM and the password at
the prompts:
Username: SYSTEM
Password: your_password
The DCL prompt appears.
Step 2: If you have not already read the installation script from the
installation media as described in the SYBASE installation
procedure (subsection 3.5), insert and make ready the media,
and read the script by entering the following command at the
DCL prompt:
$ backup tapedrive:syb_envox_inst.a/sav *.*/new
where tapedrive is the name of your tapedrive if upgrading
from tape, or the full directory pathname where the savesets
are stored if upgrading from disk.
Step 3: Start the installation script by entering the following command
at the DCL prompt:
$ run sybase_envox_install
The screen clears and the following display appears:
Checking system
Please wait...
6