Installation manual

75
Upgrading Software on Client-Server Systems
F Section 5
Installin g and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
5.5 Reloading P4.0 ENVOX Software
This subsection describes how you reload P4.0 ENVOX software. Two
reasons you might need to reload ENVOX P4.0 software on a system
already running P4.0 are:
J You are a customer who has an agreement with
Fisher-Rosemount Systems to implement pre-release software
products in controlled environments called Beta sites. These sites
must then reload P4.0 when the final software version is released.
J In some circumstances, existing ENVOX P4.0 files have become
corrupted or have been inadvertently deleted and, as a result, you
must re-load version P4.0.
It is suggested that you read the subsection 5.1.1 to understand
the upgrade precautions.
Note ...
To reload ENVOX P4.0, perform the following steps:
Step 1: If you are not logged into the system manager’s account, log
in by entering the user name SYSTEM and your password at
the prompts:
Username: SYSTEM
Password: your_password
The DCL prompt appears.
Step 2: Insert and make ready the installation media, and read the
installation script from the media by entering the following
command at the DCL prompt:
$ backup tapedrive:syb_envox_inst.a/sav *.*/new
where tapedrive is the name of your tapedrive if upgrading
from tape, or the full directory pathname where the savesets
are stored if upgrading from disk.
Step 3: Start the installation script by entering the following command
at the DCL prompt:
$ run sybase_envox_install
The screen clears and the following display appears:
5