Installation manual

67
Upgrading Software on Client-Server Systems
F Section 5
Installin g and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
Tape Characteristics
--------------------
1)Tape device filename =
2)Tape Capacity(Mb) =
ENTER QUIT
Step 12: Enter the tape device filename (for example,
MKA100:ENVOXDB.PDX) and the tape capacity. Then, move
the cursor to ENTER and press Return.
The following display appears if you are dumping to tape:
Checking tape characteristics
Please wait...
Followed by the next display:
PDX dump of database dbname in progress
Please wait...
If a small tape capacity was set, the following display
appears:
Tape capacity has been reached.
Put next tape into drive.
.
.
.
Press <CR> to continue, Ctrl-Z to exit.
Step 13: Put the next tape into the drive, and press Return.ThePDX
dump process will continue. If another tape is needed, the
prompt is repeated.
When the verification phase is reached, the following display
appears:
PDX entering verification phase.
Please insert first tape for this database.
.
.
.
Press <CR> to continue, Ctrl-Z to exit.
5