Installation manual

Section 5 F Upgrading Software on Client-Server Systems

Installing and Upgrading ENVOX

Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)

Step 8: Move the cursor to PDX DUMP DATABASES, and press

Return.

The following display appears:

PDX dump a database or install.

Move cursor to item and press <CR>

PDX dump <TYPE> database <DBNAME>

INSTALL

QUIT

There is a PDX dump selection for every database which was

listedinStep6.

Step 9: Move the cursor to the PDX dump line of the database you

want to PDX dump, and press Return.(Ifyoudonotwishto

dump data from any of the databases, you may choose

INSTALL).

The following display appears:

PDX dump to tape or to disk.

Move cursor to item and press <CR>

PDX DUMP DATABASE TO TAPE

PDX DUMP DATABASE TO DISK

QUIT

Step 10: If you intend to use a tape dump device, proceed to Step 11;

if you intend to use a disk dump device, proceed to Step 16.

Step 11: To dump to tape, insert a pre-initialized tape into the tape

drive. If you intend to use the tape drive used by the

installation, then first remove the installation tape before

inserting a pre-initialized tape. Move the cursor to

PDX DUMP

DATABASE TO TAPE

, and press Return.

The following display appears: