Installation manual

Section 4 F Installing ENVOX Software
44
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
Step 11: For menu item 7): to install from tape, enter the tape device
name where the ENVOX software media is located. To install
from disk, enter the full directory pathname where the
savesets are stored.
Step 12: Move the cursor to ENTER and press Return to continue the
installation.
The following display appears:
Checking menu options
Please wait...
If there are no errors, the following display appears:
Options validated OK
Move cursor to item and press <CR>
PROCEED WITH INSTALLATION
MODIFY OPTIONS
QUIT
Step 13: Move the cursor to PROCEED WITH INSTALLATION and
press Return to continue the installation.
If there are no errors, the installation continues to completion.
During installation, the following display appears:
start of inst_upg_envox.com
Deleting existing ENVOX files..
Installing ENVOX files...
upgrading master database
upgrading database master to ENVOX P4.0 Dec 12 1997 5:37PM
master upgrade complete Dec 12 1997 5:37PM
CREATING ENVOX P4.0 DATABASES ...
The installation process is about to enter a phase where the
ENVOX configuration databases are created.
This will take about 1 to 2 hours to complete.
Installation of ENVOX software is complete.
For new installations you will be prompted to change your
password when you first log into the ENVOX and ENVOXSUPPORT
accounts. Please enter a valid password and keep it safe.
ENVOX install completed successfully on 12-Dec-1997 18:29:17.12
4