Installation manual

37
Installing SYBASE Software
F Section 3
Installin g and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
not yet installed TCP/IP software, then leave this field blank.
You can configure the SYBASE server to allow TCP/IP entry
after installing CDOS.(see section 12).
Step 14: For menu item 9), enter the name of the node where the SQL
server resides. A valid entry for the node name and address
must exist in the client’s NCP database and be reachable. To
verify that a valid node_name and node_address exist, enter
the following:
$ mcr ncp loop node node_name
$ mcr ncp loop node node_address
where node_name and node_address are the ones in your
system. If no errors are displayed, a valid node exists and is
reachable.
To add a new node name and node address, enter the
following:
$ mcr ncp define node node_address NAME node_name
$ mcr ncp set node node_address NAME node_name
where node_name and node_address are the ones you want
to use. The node name must contain only alphanumeric
characters, dollar ($) signs, or underscore ( _) characters. It
must be 12 characters or less.
Step 15: For menu item 10): To install from tape, enter the tape device
name where the ENVOX software media is located. To install
from disk, enter the full directory pathname where the
savesets are stored.
Step 16: Move the cursor to ENTER and press Return to continue the
installation.
The following display appears:
Checking menu options
Please wait...
If there are no errors, the following display appears:
Options validated OK
Move cursor to item and press <CR>
PROCEED WITH INSTALLATION
MODIFY OPTIONS
QUIT
3