Installation manual

Section 3 F Installing SYBASE Software
26
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
3.2.3 Initializing t h e Second Disk Drive
The following steps let you initialize the second (external) disk drive and
should only be carried out on disks which have not been initialized. The
second disk drive must be initialized as shown so that there is enough
contiguous disk space on the disk to load the SYBASE database
software.
To initialize the second disk drive:
Step 1: If you are not logged into the system manager’s account, log
in by entering the user name SYSTEM and the password at
the prompts:
Username: SYSTEM
Password: your_password
The DCL prompt appears.
Step 2: Enter the following command at the DCL prompt:
$ initialize/index=beginning seconddisk: user$1
Step 3: Mount the disk by entering the following command at the DCL
prompt:
$ mount/system seconddisk: user$1 user$1
This command mounts the disk and creates the logical
USER$1 which can be used during the installation to refer to
the disk.
Step 4: Edit the file SYS$MANAGER:SYSTARTUP_VMS.COM to add
a line with the mount command shown in Step 3. This action
makes sure that the disk is mounted when the system is
rebooted. The line must be positioned before any lines which
start any PROVOX
R
systems software and SYBASE software
used in the ENVOX system.
3