Installation manual

Section 3 F Installing SYBASE Software

Installing and Upgrading ENVOX

Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)

3.2.2.4 Recovering SCSI ECO Kit From the Con trol Desktop CDROM

Recovering the SCSI ECO kit from the Control Desktop CDROM requires

copying the kit to a directory on your PC hard drive, and then transferring

the kit to your AXP workstation over your network using file transfer

protocol (FTP).

You may recove r the kit before or after Control Desktop installation, but

do not recover the kit during Control Desktop installation.

From your PC, copy the ECO Kit file from the CDROM onto the PC disk,

as follows:

Step 1: Using Windows Explorer, create a folder on the hard drive (for

example, C:\Axpatch).

Step 2: Insert the Control Desktop CDROM in the PC CDROM drive.

Step 3: Using Windows Explorer, copy the ECO Kit file from the

CRROM to the folder.

For example, copy it from E:\Axpatch\ALPSCSI02_071.A to

C:\Axpatch\ALPSCSI02_071.A where E drive is the CD ROM

drive and C is the local PC hard drive.

Step 4: Open an MS DOS window and enter:

$C: sele cts the C drive

$cddirectory_name changes directory to the one

you named above

$ ftp alpha_nodename selects the AXP workstation

node for the transfer

...where directory_name is the name of the directory where

the ECO Kit file is located (for example, axpatch), and

alpha_nodename is the name of the node for your AXP

workstation.

When you enter the last command, you will be prompted for a

username and password.