Installation manual

Section 3 F Installing SYBASE Software

Installing and Upgrading ENVOX

Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)

3.2.2.2 Installing Year 2000 ECO Kits (VAX an d AXP Platforms)

An ECO kit VAXY2K01_071 for VAX systems and an ECO kit

ALPY2K01_071 for AXP systems must be applied, after installing Motif

software and before attempting the SYBASE installation. The following

steps let you determine whether or not the ECO kit has been installed

and, if it has not, include instructions on how to install it.

Step 1: If you are not logged into the system manager’s account, log

in by entering the user name SYSTEM and your password at

the prompts:

Username: SYSTEM

Password: your_password

The DCL prompt appears.

Step 2: Enter the following command at the DCL prompt:

$ dir sys$help:Y2K.release_notes

If the file exists, the ECO kit has been applied and no further

action is required. If the file does not exist, proceed to Step 3.

Step 3: Insert and make ready the installation media and install the

ECO kit by entering the following command at the DCL

prompt:

J For a VAX system, enter:

$ @sys$update:vmsinstal VAXY2K01_071 tapedrive:

J For an AX P system, enter:

$ @sys$update:vmsinstal ALPY2K01_071 tapedrive:

...where tapedrive is the name of your tapedrive or directory

location.

Step 4: Reboot the system after the ECO kit has been successfully

installed. To reboot the system, enter the follo wing commands

at the DCL prompts:

$ @sys$login:login

$ reboot