Installation manual

21
Installing SYBASE Software
F Section 3
Installin g and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
3.2.2.1 Installing M otif ECO Kit (AXP Platform Only)
An ECO kit ALPMOTF03_U4012 for AXP systems must be applied, after
installing Motif software and before attempting the SYBASE installa tion.
The following steps let you determine whether or not the ECO kit has
been installed and, if it has not, include instructions on how to install it.
Step 1: If you are not logged into the system manager’s account, log
in by entering the user name SYSTEM and your password at
the prompts:
Username: SYSTEM
Password: your_password
The DCL prompt appears.
Step 2: Enter the following command at the DCL prompt:
$ dir sys$help:ALPMOTF03_U4012.release_notes
If this file exists, the ECO kit has been applie d and no further
action is required. If the file does not exist, proceed to Step 3.
Step 3: Insert and make ready the installation media and install the
ECO kit by entering the following command at the DCL
prompt:
$ @sys$update:vmsinstal ALPMOTF03_U4012 tapedrive:
...where tapedrive is the name of your tapedrive or directory
location.
Step 4: Reboot the system after the ECO kit has been successfully
installed. To reboot the system, enter the follo wing commands
at the DCL prompts:
$ @sys$login:login
$ reboot
3