Installation manual

149

Error Messages

F Appendix A

Installing and Upgrading ENVOX

Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)

Figure A-Table A

Appendix A

A Error Messages

This appendix lists messages that can occur during various stages of the

installation process. This section is organized as follows:

J Pre SYBASE/ENVOX Error Messages — Subsection A.1

J SYBASE Error Messages — Subsection A.2

J ENVOX Error Messages — Subsection A.3

J PDX Dump Error Messages — Subsection A.4

J CDOS Error and Warning Messages — Subsection A.5

A.1 SYBASE and ENVOX Pre-Installation Error Messages

This subsection contains error messages that can occur before you select

whether to install or upgrade SYBASE or ENVOXr software.

Message You must run the installation from the system account.

Description You must log into the system account to carry out the installation.

Message You must run the installation from the sys$manager

directory.

Description Ensure that the current directory is SYS$MANAGER by issuing the

command: show default

Message SYBASE and ENVOX must be installed on OpenVMS 7.1 or

later.

Description Upgrade your OpenVMS software to the latest version of OpenVMS and

try again.