Installation manual

Section 12 F Installing and Upgrading CDOS for Control Desktop
144
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
J cdos_system:[cdos]start_cdos_servername.out file. This file is
re-created each time the CDOS server is started and so contains the
log from the current run of the CDOS server only.
If the CDOS server has started successfully, the following line is seen at
the end of both files:
date, time CDOS startup complete - going
multi-threaded
12.11.3 Stopping the CDOS Server
To stop the CDOS server, log into the cdos account and type the following
at the prompt:
$ stopcdos_server_name
For example, to stop the CDOS server named, CDOS, the command
would be:
$ stopcdos
12.11.4 Starting the Task Daemon
To start the task daemon, log into the cdos account and enter the
following at the prompt:
$ starttd
This command produces output to the task daemon log file. The file name
is given in the task daemon configuration file (described in subsection
12.11.10). The default name is cdos_system:[cdos]td.log. If the task
daemon has started successfully, the following line is seen at the end of
the task daemon log file.
date, time Initialisation complete
12.11.5 Stopping the Task Daemon
To stop the task daemon, log into the cdos account and enter the
following at the prompt:
$ stoptd
12.11.6 Starting the Diagnostic Daemon
To start the diagnostic daemon, log into the cdos account and enter the
following at the prompt:
12