Installation manual

141
Installing and Upgrading CDOS for Control Desktop
F Section 12
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
12.10 Network Routing
If you need to communicate with a host on a different IP network, then a
default gateway should be set up. The following steps describe how to
verify and configure a default gateway on a system installed with UCX
and MULTINET.
12.10.1 Routing using UCX
To determine whether a default gateway has been configured on a
system installed with UCX, enter the following:
Step 1: If you are not logged into the systems manager’s account, log
in by entering the user name SYSTEM and your password, at
the prompt.
Username: System
Password: your_password
The DCL prompt appears.
Step 2: Enter the following command at the DCL prompt:
$ ucx show route */full/perm
The following is displayed:
Type Destination Gateway
PN * 0.0.0.0 * gateway ip address
If an entry does not exist in the Gateway column, then a
default gateway has not been configured. Perform the next
step to configure a default gateway:
Step 3: Enter the following at the DCL prompt:
$ UCX
UCX> set router/default/gateway=your_gateway_ip_
address/perm
UCX> set router/default/gateway=your_gateway_ip_
address
12