Installation manual

Section 12 F Installing and Upgrading CDOS for Control Desktop
140
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
...or whatever is the correct parameter for your system.
If TCP/IP software is installed and running, the TCP/IP
address of the host will be displayed.
Step 8: Verify that the INET driver has been configured. At the prompt,
enter:
$ show dev INET0
If the INET driver has been configured then the following will
be displayed:
INET0: Online
12.9.4 Specifying Servers in the Interface File
The logical DSQUERY is used to specify which of the servers listed in the
interfaces file is used when you use ISQL or the ENVOX forms to access
a server. The interfaces file is located in,
sybase_system:[sybase]interfaces
DSQUERY is defined at login and is set to cdos_servername (for
example, CDOS) if logged into the cdos account or otherwise
sybase_servername (for example, SYBASE).
To determine the value of DSQUERY, enter the following at the DCL
prompt:
$ show logical DSQUERY
If the logical is defined, the system displays:
“DSQUERY” = “servername” (LNM$PROCESS_TABLE)
If the logical is undefined, the following display appears:
$ %SHOW-S-NOTRAN, no translation for logical name
DSQUERY
To change the value of DSQUER Y, enter the following:
12