Installation manual

137
Installing and Upgrading CDOS for Control Desktop
F Section 12
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
Step 7: Verify that Multinet is running and TCP/IP is operational by
entering:
$ show system
The process MULTINET_SERVER should be displayed.
$ Multinet ping/number_of_packets = 1 orange
...or whatever is the correct parameter for your system.
If TCP/IP software is installed and running, the TCP/IP
address of the host will be displayed.
Step 8: Verify that the INET driver has been configured. At the prompt,
enter:
$ show dev INET0
If the INET driver has been configured, the following will be
displayed:
INET0: Online
12.9.3 UCX Installation
The following guidelines use an example of installing UCX Version 4.0 on
AXP node, ORANGE, and tcp/ip address of 129.36.21.146. Substitute the
nodename, tcp/ip address, routing information, and UCX product name of
your system in the appropriate places below.
Step 1: Step 1. If you are not logged into the system manager’s
account, log in by entering the user name SYSTEM and your
password at the prompt.
Username: System
Password: your_password
The DCL prompt appears.
Step 2: Insert and make ready the installation media, and invoke the
installation, by entering the following command at the DCL
prompt:
$ @sys$update:vmsinstal ALPHA_UCX040 tapedrive:
... where tapedrive is the name of your tapedrive if installing
from tape, or the full directory pathname where the savesets
are stored if installing from disk.
12