Installation manual

Section 12 F Installing and Upgrading CDOS for Control Desktop

136

Installing and Upgrading ENVOX

Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)

$ set default sys$sysdevice:[multinet.axp_common.multinet]

$ @configure

When the following display appears, fill in the applicable

entries for your system:

* System specific directory name:

[dka200:[multinet.orange]]: <CR>

* Enter your Internet host name:

orange.pit.leicester.fisher.com

* Enter the Internet(IP) Address for interface ESA0:

129.36.21.146

* Enter the subnet mask for interface ESA0:

255.255.255.0

* Enter the Internet(IP) Address of your default

route: 129.36.21.1

* Use Domain Nameservice instead of host tables [YES]

YES

* Enter your local timezone: BST

Step 4: Specify the local computers host name, by entering:

$ multinet configure/interface

When the following display appears, fill in the applicable

entries for your system

NET-CONFIG>sethost-nameorange.pit.leicester.fisher.com

NET-CONFIG> set domain-nameserver 129.36.21.20

NET-CONFIG> show

NET-CONFIG> exit

Step 5: Update systartup_vms.com to allow multinet to start at boot

time by editing sys$manager:systartup_vms.c om to include

the following line:

@sys$sysdevice:[multinet.orange.multinet]

start_multinet.com

Step 6: Reboot your system by entering:

$ reboot