Installation manual

135
Installing and Upgrading CDOS for Control Desktop
F Section 12
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
12.9.2 Multinet Installation
The following guidelines use the example of installing Multinet Version 4.0
on AXP node, ORANGE, and a TCP/IP address of 129.36.21.146.
Substitute the nodename, TCP/IP address, routing information, and
multinet product name of your system in the applicable places below.
Step 1: If you are not logged into the system manager’s account, log
in by entering the user name SYSTEM and your password at
the prompt.
Username: System
Password: your_password
The DCL prompt appears.
Step 2: Insert and make ready the installation media, and invoke the
installation, by entering the following command at the DCL
prompt:
$ @sys$update:vmsinstal MULTINET040 tapedrive:
... where tapedrive is the name of your tapedrive if installing
from tape, or the full directory pathname where the savesets
are stored if installing from disk.
When the following display appears, fill in the applicable
entries for your system:
* Do you want to install the TCP/IP application [YES]
YES
* Do you want to install the online documentation
[YES] YES
* Do you want to install the library files [YES] YES
* Do you want to install the user commands in
DCLTABLES [YES] YES
* Configure Multinet TCP/IP after installation [NO]
“
“
VMSINSTAL procedure done at 14:02
Step 3: Configure the IP transport by entering:
12