Installation manual

131
Installing and Upgrading CDOS for Control Desktop
F Section 12
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
A message is displayed stating that the database has not been
upgraded and asking if it should be upgraded now.
Step 2: Select Yes or No
If “Yes” is selected, you are prompted to enter the password
for the envoxutility Sybase server account.
Step 3: Enter your password for the envoxutility account.
On a newly installed system, the password is set to:
envoxutility.
If you do not know the password for the envoxutility account,
you can change the password from isql, as follows:
Log into ISQL by entering:
$ define DSQUERY sybase_server_name
$ ISQL/u=”sa”/p=“sa_password”
...where sybase_server_name is the name of your Sybase
server (for example, SYBASE) and sa_password is your
current password for the Sybase server sa account.
The quotation marks (“”) are required.
The system responds with the ISQL prompt.
Step 4: At the ISQL prompt, enter in order:
1> sp_password ”sa_password“,”new_password”,
envoxutility
... where sa_password is your current password for the sa
user and new_password isthepasswordyouwishtousefor
the envoxutility account.
The quotation marks (“”) are required.
2> go
After go is entered, the following display should appear:
Password correctly set,
(return status = 0)
1> exit
When you enter exit, upgrade of an ENVOX database begins.
Enter your new envoxutility password when prompted during
the upgrade.
12