Installation manual

123
Installing and Upgrading CDOS for Control Desktop
F Section 12
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
12.5 Installing CDOS
Installation is a stepped procedure, requiring several keyboard entries
and selections during the process. Be sure to follow the procedure
carefully.
If your system is already installed with CDOS version P1.0 and
you wish to upgrade CDOS to version P2.0, then proceed to
subsection 12.6.
Note ...
To install CDOS, proceed as follows:
Step 1: If you are not logged into the system manager’s account, log
in by entering the user name SYSTEM and your password at
the prompt.
Username: System
Password: your_password
The DCL prompt appears.
Step 2: Insert and make ready the installation media. Then, read the
installation script from the installation media by entering the
following command at the DCL prompt:
$ backup tapedrive:cdos_inst.a/sav *.*/new
... where tapedrive is the name of your tapedrive if installing
from tape, or the full directory pathname where the savesets
are stored if installing from disk.
Step 3: Invoke the installation script by entering the following
command at the DCL prompt:
$ run cdos_install
The screen clears and the following display appears:
Checking system
Please Wait....
Then, the following display appears:
12