Installation manual

121
Installing and Upgrading CDOS for Control Desktop
F Section 12
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
On the PC running Control Desktop, the ServerSetup program should be
run and the two server names defined. Assuming the names used in the
example above, they would be entered in the list box at the top section of
the program screen as:
CDOS 129.76.21.146, 7010
SYBASE 129.76.21.146, 2025
In the bottom section of the screen, the CDOS Open Server name would
be CDOS and the Default Sybase Server name would be SYBASE. The
Default Database would be your ENVOX database name (for example,
ENVOXDB).
Notice in the example that the CDOS server and Sybase server
port numbers are not the same. A separate port number is
required for each server. The numbers 7010 and 2025 are the
default numbers.
Note ...
Once the Sybase server entry in the interfaces file has been updated with
the TCP/IP address, and the Sybase server has been restarted, lines
similar to the following should exist in the file start_servername.out in the
directory, sybase_system:[sybase.install].
Initializing Additional Master Network 129.76.21.146.
Object 2025, Listener 1
If your Sybase server is named SYBASE, the file name is
sybase_system:[sybase.install]start_sybase.out.
12