Installation manual

119
Installing and Upgrading CDOS for Control Desktop
F Section 12
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
12.3.3 Verifying TCP/IP Installation
The TCP/IP software should always be installed and configured, following
the instructions in the vendor-supplied Installation and configuration
manuals. The Troubleshooting subsection, 12.9, provides a guide to
installing Multinet and UCX on OpenVMS system.
Do not omit the following verification procedures. You must be
sure that TCP/IP software is installed and running, and the INET
driver is configured. Unless they are, CDOS will not successfully
install.
Caution ...
To verify that the TCP/IP software is installed and running on the host
system, enter the appropriate command at the prompt:
J If Multinet is installed, enter:
$ Multinet ping/number_of_packets=1 hostname
J If UCX is installed, enter:
$ UCX ping/number_of_packets=1 hostname
where hostname is the name of your host system.
If TCP/IP software is installed and running, the TCP/IP address of the
host is displayed. If the address is not displayed, TCP/IP software
installation is required. See the installation manuals which are supplied
with the software.
To verify that the INET driver has been configured, enter the following
command at the prompt:
$ show device INET0
If the INET driver has been configured, the following display appears:
INET0:Online
If TCP/IP is installed, but not running or the INET driver is not
configured, refer to the Troubleshooting information in
subsection 12.9.
Note ...
12