Installation manual

Section 12 F Installing and Upgrading CDOS for Control Desktop
116
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
However, in practice the limit may be lower depending on CPU size,
memory size, and the load imposed by other applications running on the
system.
CDOS can be installed on a workstation which has ENVOX
software installed in Client-Server or Client-Only mode. If
ENVOX software is installed in client-server mode with the
SYBASE server running, it will need more resources for CDOS
and a given number of Control Desktop clients than if ENVOX
software is installed in client-only mode.
Note ...
12.2.2 Software Requirements
The following software is required:
J ENVOX P4.0 software installed in client-server or client-only mode.
CDOS P2.0 is only compatible with ENVOX P4.0.
J Software which allows the DEC machine to communicate with PC
clients via TCP/IP. The third party software can be either MULTINET
or UCX. The package must be installed and running before a Control
Desktop client will communicate with CDOS.
12.2.3 Disk Space Requirements
Installation requires the following free disk space:
J 1000 free blocks for DEC VAX and DEC AXP on the SYBASE
application disk. This space is required to hold additional sybase files.
J 22000 free blocks for DEC VAX and 32000 free blocks for DEC AXP
on the CDOS application disk. This space is required to hold the
CDOS software.
J 5000 free blocks on the system disk. This space is required to hold
temporary files during the installation. The files will be deleted at the
end of installation.
12.2.4 Installation Time
Installation time on a VAX machine takes about 15 minutes. On an AXP
machine, it takes about 10 minutes.
12