Installation manual

Section 10 F System Tuning
106
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
Step 9: Enter Y if you wish to continue.
The following display appears:
checking system parameters...
initializing the SYBASE server with the new parameters...
sybase_tune completed successfully on 12-JAN-1998 08:12
If sybase_tune does not proceed as expected, there is a log file which
you can review to help you determine the cause. The file,
sybase_tune.log, is produced in the sybase_device:[sybase.install]
directory.
Table 10-1 provides approximate memory requirements for the
applications listed in the table.
Do not specify more users than are required. A higher number of
users affects system performance.
Note ...
Table 10-1. Non-Standard Installation Memory Requirements
Application Memory Requirements
(Mbytes)
OpenVMS 3.0
Motif 5.0
DECwindows Motif 3.5
Each Envox
R
+ Display Editor session (Motif)
4.5
CHIP 0.5
Table 10-2 gives the minimum computer configuration needed to support
both the Sybase SQL server and the CDOS server.
Table 10-2. Minimum Computer RAM Needed to Support Server RAM
Computer Type Computer RAM Sybase Server RAM CDOS Server RAM
(1)
VAX 64Mb 16Mb 4Mb
AXP 64Mb 16Mb 4Mb
3. The values in this column are initial ones. They will grow as necessary if the physical memory is
available. The values are p re-configured, and are not prompted-for by sybase_tune.
The amount of physical memory allocated to the Sybase server impacts
the number of concurrent ENVOX software, Control Desktop, and Control
Designer users that can be supported. sybase_tune indicates the
10