Installation manual

Section 10 F System Tuning
104
Installing and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
Step 4: Enter a value determined as follows:
J If you do not have Control Desktop installed, enter 0.
J If you have Control Desktop installed, use Table 10-3 to
help determine the number of Control Desktop users you
may enter.
If you enter a value greater than 0 for the number of Control
Desktop users, the following appears:
How many of the Control Desktop users will use
Control Designer? [0]:
Step 5: Enter a value for the number of Control Desktop users that will
use Control Designer.
The following display appears:
How many of the Control Desktop users will use
Display Designer? [0]:
Step 6: Enter a value for the number of Control Desktop users that will
use Display Designer.
The following display appears:
Specify, in megabytes, the memory available
for the SYBASE server [16]:
Step 7: Enter the memory allocated to the SYBASE dataserver.
When deciding how much memory to allocate to the
SQLserver, note that the minimum memory required by the
server is 16 Mbytes and the maximum memory is 64 Mbytes.
However, no more than half of the system memory can be
allocated to the SQL server. Also take into account that
additional memory is required by the applications listed in
Table 10-1.
The following display appears:
Do you wish to see the list of VMS system
resources required by the SYBASE server? [Y]
Step 8: Enter Y if you wish to see the list of VMS system resources
required by the SYBASE server. The VMS system resources
are dependant on the number of users, SYBASE server
memory and type of system and will vary from the values listed
below.
The following display appears:
10