Installation manual

Section 8 F Backing Up, Restoring, and De-Installing Software

Installing and Upgrading ENVOX

Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)

8.5 De-installing ENVOX and SYBASE Software

The de-install proce ss completely removes ENVOX and SYBASE

software from your system. All SYBASE databases, files, and directories

are deleted, all ENVOX files and directories are deleted, and all SYBASE

and ENVOX accounts are deleted. You cannot choose to de-install

SYBASE or ENVOX software separately.

To de-install, you must first retrieve the installation scripts from tape

using the instructions in subsection 3.3 step 2. Then, log into the

computer as System and enter the following commands at the prompts:

$ @DEINSTALL_SYBASE_ENVOX.COM

When you enter this command, the system responds with:

This utility will completely de-install SYBASE and

ENVOX. All SYBASE databases, SYBASE files and

directories will be deleted. All ENVOX files and

directories will be deleted. All SYBASE and ENVOX

accounts will be the deleted.

Do you wish to continue [N] ?

Enter N if you wish to save any files or wish to first backup the system.

Enter Y only if you are absolutely sure that you wish to continue.

Alternatively, de-install may be carried out using the install utility. Log into

the computer as System and enter the following commands at the

prompts:

Step 1: This step assumes that you have obtained the installation

scripts from tape as described in subsection 3.3 step 2. At the

prompt, type the following:

$ run sybase_envox_install