Installation manual

95
Backing Up, Restoring, and De-Installing Software
F Section 8
Installin g and Upgrading ENVOX r Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)
Step 3: When the tape that is being read reaches its end (except for
the last tape in a set of tapes), several end-of-tape messages
are displayed.
%BACKUP-I-RESUME, Resuming operation on
volume n
%BACKUP-I-READWRITE, Mount column n on
tapedrive:
for reading
Load the next tape. Make sure that you insert the backup
tapes in the correct order. When the tape is ready, enter Y at
the prompt:
Enter YES when ready: Y
Step 4: When the restoration is complete, the following messages are
displayed:
%BACKUP-I-PROCDONE, Operation completed. Processing
finished at dd-mmm-yyyy hh:mm:ss.xx
If you do not want to perform another standalone
backup operation, use the console to halt the system.
If you do want to perform another standalone BACKUP
operation, ensure the standalone application volume
is on line and ready.
To continue, enter Y at the prompt:
Enter YES when ready: Y
Step 5: To restore your second disk drive, repeat Step 2 through
Step 4, using the name of your second disk drive in place of
diskdrive in the commands.
The messages are displayed a second time when the tape or
tapes for the second disk have been restored.
Step 6: When all tapes have been restored, press the halt button on
the back of your computer. When the console mode prompt
(
>>>) appears, reboot the system by entering:
>>> BOOT systemdisk
where systemdisk is the name of your system disk.
Restoration of the system is complete.
8