Installation manual

Backing Up, Restoring, and De-Installing Software

F Section 8

Installin g and Upgrading ENVOX

Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)

Step 4: Enter the following command at the console-mode prompt

(>>>) to display the list of device names:

>>> SHOW DEVICE

Step 5: Enter the following command to boot the backup routine:

>>> B tapedrive

where tapedrive is the name of the tape drive as listed in the

SHOW DEVICE display.

Step 6: Enter the date and time as indicated.

PLEASE ENTER DATE AND TIME (DD-MMM-YYYY

HH:MM) dd -mmm-yyyy hh:mm

Enter the date and time in the requested format. For example,

for 2:30 pm, April 8, 1996, enter 08-APR-1996 14:30.

A confirmation message appears, followed by the DCL prompt.

8.2 Booting Standalone Backup on AXP Systems

Perform the following to boot the standalone backup routine:

Step 1: Enter the following command at the DCL prompt to shut down

your system:

$ @SYS$SYSTEM:SHUTDOWN

Step 2: After the system has shut d own, press the halt button on t h e

rear of the unit.

Step 3: Insert the distribution compact disc into the drive.

Step 4: Enter the following command at the console-mode prompt

(>>>) to display the list of device names:

>>> SHOW DEVICE

Step 5: Enter the following command to boot the backup routine:

>>> BOOT -flags 0,0 source_drive

where source_drive is the name of the compact disc drive as

listed in the SHOW DEVICE display.

Step 6: After the source drive is booted, the system displays a menu

from which you can select various tasks. Choose the menu

item which lets you execute DCL prompts and procedures.