Installation manual

Section 8 F Backing Up, Restoring, and De-Installing Software

Installing and Upgrading ENVOX

Configuration Software on DEC VAX and DEC AXP Systems (Revision B — May 1998)

Step 3: At the prompt for the device name, enter the name of the

system disk.

This action creates the standalone backup on disk.

8.1.2 Booting the Standalon e Backup from Disk

After creating the standalone backup on disk, perform the following to

boot the standalone backup routine from disk:

Step 1: Enter the following command at the DCL prompt to shut down

your system:

$ @sys$system:shutdown

Step 2: After the system has shut d own, press the halt button on t h e

rear of the unit. When the

>>> prompt is displayed, enter the

following command to boot the backup routine:

>>> B/E0000000

Step 3: Enter the date and time as indicated:

PLEASE ENTER DATE AND TIME (DD-MMM-YYYY

HH:MM) dd -mmm-yyyy hh:mm

Enter the date and time in the requested format. For example,

for 2:30 pm, April 8, 1996, enter 08-APR-1996 14:30.

A confirmation message appears, followed by the DCL prompt.

8.1.3 Booting the Standalon e Backup from Tape

Perform the following to boot the standalone backup routine from tape:

Step 1: Insert and load the VMS installation media containing the

standalone backup utility. Refer to the OpenVMS Version 7.1,

Installation and Upgrade Manual.

Step 2: Ente r the following command to shut down your system at the

DCL prompt:

$ @sys$system:shutdown

Step 3: After the system has shut d own, press the halt button on t h e

rear of the unit.