User manual

SVA026 Netcom 2 User Manual ver5

Service Pack 2 is installed on a computer it will turn on the personal firewall. Below are

the steps to open up the web port for Netcom in Windows XP Firewall:

 Select Start Menu > Control Panel.

 Select Network Connections and right click on the connection that is

being used.

 Click on Properties and click the Advanced tab in the Properties

dialogue.

 Press the Settings... button to bring up the Firewall dialogue.

 Go to the Exceptions tab and click the Add Port button.

For Name enter Netcom Web Port and for Port Number enter 80. Press the OK

button.

You now will be able to access the Netcom web port through the Windows XP

Firewall.

4.Howdo IConfiguretheNetcom?

4.1InstallingtheNetcomUtilities

The Netcom CD contains the following:

 SNMP MIB

 Netcom User Manual (PDF)

 Shut down installation procedure

 Netcom FAQ

 Firmware

To install the Netcom Utilities or access any of the documents, place the Netcom CD in

the CD

drive. The Netcom Utilities CD should automatically start. Follow the instructions

provided on

your screen.

4.2 Configuring the Netcom

The initial network settings can be made by connecting the Netcom to a serial

communication program using the included configuration cable or cross over cable and

laptop.

4.2.1 HyperTerminal Setup example (serial cable)

1. Connect the 9 pin connector to the PC and the 9 pin receptacle labeled “Serial

RS232” on the Netcom.