User manual
SVA026 Netcom 2 User Manual ver5
36
7.15SNMPNMS/SetupSNMPPage
Figure 7.15
The Setup/SNMP NMS function is used to set up the network management
station that will be viewing the UPS information using GETs and SETs. The Get
operation is used by the NMS to obtain the necessary information and the SETs
command are used to configure the management device for the information. The network
management stations that must access the units SNMP function must be entered at this
page. For each Network Management Station the following must be entered.
NMS IP Address- Enter the IP address for the NMS
Community – Enter the SNMP community string the NMS will use. Contact your
system administrator for details
NMS- The read only access permits the network management station to use only
GET commands. The Read/Write access permits the network management station
to use both GET and SET commands.
Note: A copy of the Netcom MIB files can be found on the Netcom CD, www.meppi.com,
or in Appendix B of this manual.