User manual

SVA026 Netcom 2 User Manual ver5
33
7.12IPConfig/Setup/IPConfigurationPage
Figure 7.12
At the Setup/ IP Configuration page the System name, IP address, Subnet Mask,
Gateway, and Config Protocol can be change. The name that will appear in the upper
right hand of ALL screens is set in the System Name box. Check with your IT
administrator for recommended settings. The Config Protocol can be set to static,
Dynamic Host Configuration Protocol (DHCP) or Bootstrap Protocol (Bootp) by using
the drop down box. The IP address can be set from this screen, however once the IP
address is set and any screen is saved the user will not be able to access the Netcom2
from the set IP address, the Netcom2 will be set to the new IP address.