Owner`s manual

6.8 Save EEPROM to TK Tape (Optional)
If your system has a TK tape, save EEPROM to the TK. This
tape would be used in case the EEPROM contents become
corrupted and must be restored.
Example 6–9: Saving EEPROM to TK Tape
>>> SAVE EEPROM
Proceed with save to tape? (Y or N) >>> Y
?006B EEPROM saved to tape successfully
>>>
Put a blank cartridge in the TK drive, write-enabled. The following steps
save the contents of the EEPROM to TK tape:
Enter the SAVE EEPROM command (see ).
The console program queries you (see ). Enter Y to save the EEPROM
contents to tape. The console program then confirms that the save
operation completed successfully.
Label the cartridge and store on site. Leave the TK cartridge with the
system manager, in case EEPROM contents become corrupted and need to
be restored.
NOTE: Use this TK cartridge with this system only. TK tapes are not
transferable, since the parameters saved are system-specific.
6–18 VAX 6000: Installing Model 500 Processors