Owner`s manual

EVUCA checks ROM levels on all processors and applies the latest patches
to each processor. Example 6–4 and Example 6–5 show a sample EEPROM
update of a Model 500 two-processor system. In these examples, the boot
processor is in slot 1 of the XMI card cage, and a secondary processor is in
slot 2.
At the console prompt, boot VAX/DS. The /R5 qualifier specifies the VAX
Diagnostic Supervisor program.
At the VAX/DS prompt, run the autosizer EVSBA to attach all devices.
This process takes time now, but saves you time when you run the other
subtests.
Type SELECT ALL to select all devices in the system configuration.
SET TRACE enables printing of test numbers and names when EVUCA
runs. It allows you to follow the progress of testing.
Issue the RUN EVUCA command to start the program. The EVUCA
banner appears, with its revision level and subtest numbers. It tests
all processors and then loads test 2.
EVUCA prompts for input on what data file you want to run. Load
EMUCA.BIN to update KA65A processors. Press Return to continue
the program.
EVUCA finds and loads the data file indicated at . Program messages
inform you of progress.
EVUCA prompts you to verify that a patch is to be made. The program
requires verification for each processor to apply patches. Enter YES to
continue the program.
Verifying the System 6–11