Owner`s manual

Examples
2–1 SAVE EEPROM Command for Systems with TK Tape ..... 2–2
2–2 Record System Parameters — INITIALIZE Command ..... 2–4
2–3 Record System Parameters — SHOW ALL Command . ..... 2–5
6–1 Self-Test for Upgrading VAX 6000 System 510 to 520 . ..... 6–6
6–2 Self-Test for an H9657-CX Upgrade .................... 6–6
6–3 Setting the System Serial Number and Parameters . . ..... 6–8
6–4 EVUCA Program (Part 1) ........................... 6–10
6–5 EVUCA Program (Part 2) ........................... 6–12
6–6 Running the Vector Diagnostics . ...................... 6–14
6–7 Self-Test from System with Vector Processors ............ 6–15
6–8 System Parameters Printout . . . ...................... 6–16
6–9 Saving EEPROM to TK Tape . . . ...................... 6–18
6–10 Running UETP ................................... 6–19
B–1 Examining the XCR0 and XBER Registers . ............. B–6
Figures
1–1 KA65A Upgrade Paths .............................. 1–2
1–2 Tradeoffs Between the H9657-CX and H9657-CU Upgrades . 1–4
1–3 How to Read This Book ............................. 1–6
2–1 Power Down the System ............................ 2–6
2–2 Removing Old Modules from the XMI Card Cage ......... 2–8
3–1 Removing the +3.3V Inhibit Cable ..................... 3–1
4–1 T2019 Power Regulator Module and Bus Bar ............ 4–2
4–2 XMI Configuration When Using the H9657-CX Kit . . . ..... 4–4
4–3 Installing the H9657-CX Bus Bar ..................... 4–6
4–4 Installing the T2019 Power Regulator Module ............ 4–8
5–1 Holding the KA65A Processor . . ...................... 5–2
5–2 Inserting the KA65A Processor in an XMI Card Cage . ..... 5–4
6–1 Verification Flowchart .............................. 6–2
6–2 Return Power to the System . . . ...................... 6–4
6–3 Front Door (Inside View) ............................ 6–20
A–1 Configuration Rules for Model 500 Scalar Systems . . . ..... A–2
A–2 Scalar/Vector Configurations . . . ...................... A–4
B–1 KA65A LEDs After Power-Up Self-Test ................. B–2
v