Owner`s manual

Chapter 3
Removing the +3.3V Inhibit Cable
If the VAX 6000 Model 300 or 400 has a +3.3V XMI, you need to remove a
power-inhibit cable before installing any KA65A processors.
Go to the rear of the cabinet and unplug the small cable from connection
J1 of the H7242 regulator with the main cable to the H7206-B. Plug the
end of the main cable back into connection J1 of the H7242 regulator.
Figure 3–1: Removing the +3.3V Inhibit Cable
msb-0449C-90
H7215 (10 PIN)
H7214 (12 PIN)
H7242 (12 PIN)
INTERLOCK (2 PIN) TO H7215
H7242 Inhibit Cable
6000-300
6000-400
6000-500
PN
Rev
Date
Vendor
36-24502-01-B01
17-02522-01
A01
003
CTI
H7206-B
Removing the +3.3V Inhibit Cable 3–1