Owner`s manual

2.6 Continuing the Installation
You are now ready to proceed with the installation of the
VAX 6000 Model 500 processors. As noted in Chapter 1, you
read only the chapters that apply to your installation.
• Upgrading a Model 500 System. Proceed to Chapter 5 (Installing
the KA65A Processor) and Chapter 6 (Verifying the System).
• Upgrading a Model 300 or 400 System with +3.3V XMI. Proceed
to Chapter 3 (Removing the +3.3V Power Inhibit Cable) and then to
Chapters 5 and 6 (Installing the KA65A Processor and Verifying the
System).
• Upgrading a Model 200, 300, or 400 with an H9657-CX Kit.
Proceed to Chapter 4 (Installing the H9657-CX Kit) and then to
Chapters 5 and 6 (Installing the KA65A Processor and Verifying the
System).
• Upgrading a Model 200, 300, or 400 with an H9657-CU Kit. See the
VAX 6000 XMI Conversion Manual for directions on how to convert the
power system. You can then refer to Chapters 5 and 6 of this manual to
tell you how to install KA65A processor(s) and verify the installation.
Preparing for the Installation 2–11