Owner`s manual

As shown in Figure 1–3, you do not need to use this whole manual. You
should read different chapters depending on what kind of system you are
upgrading and how:
If you have a VAX 6000 Model 500 and are adding KA65A CPUs, you
should read:
• Chapter 2, Preparation
• Chapter 5, Installing the KA65A Processor
• Chapter 6, Verifying the System
If you have a VAX 6000 Model 300 or 400 that supplies +3.3V power,
you should read:
• Chapter 2, Preparation
• Chapter 3, Removing the +3.3V Power Inhibit Cable
• Chapter 5, Installing the KA65A Processor
• Chapter 6, Verifying the System
If you have a VAX 6000 Model 200, 300, or 400 that does not supply
+3.3V power and you can use an H9657-CX kit, you need to read:
• Chapter 2, Preparation
• Chapter 4, Installing the H9657-CX Kit
• Chapter 5, Installing the KA65A Processor
• Chapter 6, Verifying the System
If you have a VAX 6000 Model 200, 300, or 400 that does not supply
+3.3V power and you need the full power and packaging upgrade, you
must use the H9657-CU kit. The manual describing this installation is
the VAX 6000 XMI Conversion Manual. You can then read:
• Chapter 5 of this manual, Installing the KA65A Processor
• Chapter 6 of this manual, Verifying the System
Introduction 1–7