User`s manual

If you answer “No” to the setpoint setting question, ignore
the next two data entry fields. In this case, the SLS uses the
settings of the two setpoint “pots” on its access panel.
If you answered “Yes,” enter the appropriate values (0 to
100 percent) for “Set Point A” and “Set Point B” in the next
two data entry fields (you can enter decimal values having
up to two digits to the right of the decimal). The SLS uses
these values instead of the setpoint pot settings.
Note: The SLS converts the setpoint values that you enter
to the nearest storable value, which is always within 0.013
of the value that you entered.
At this point, press the PgDn key to displuy the second part
of the Configuration Screen, as shown in Figure 5.4 on
page 5-l 0.
Edge Span and Edge Height Settings
This field asks whether you want SLS to use the edge span
and edge height values that you enter in the next two data
entry fields. (Normally, you use the View Image option to
determine the appropriate span and height values, then
enter them in the two fields. For a complete description of
edge span and edge height parameters, refer to Chapter 6,
View Image Option, in this manual.)
Use the SPACE BAR to select Yes or No.
If you select Yes, the CSS sends these two values when you
download the configuration to the SLS. If you select No,
the CSS does not download these values. Instead, the SLS
uses the default values (span = 4, height = 3).
If you answered “No” to the edge span/edge height
question, ignore the two data entry fields. If you answered
“Yes,” enter the appropriate values (1 to 10) for “Edge
Span” and “Edge Height.”
5-9