User`s manual

Use Hardware Switch Settings?
This field asks whether you want the SLS to use the
settings of the DIP switches on its access panel, or the
“switch settings” (including the analysis function) that you
select in the Switch Settings section of the Configuration
Screen.
Use the SPACE BAR to select Yes or No.
If you select Yes, the SLS uses the DIP switch settings to
determine its analysis function and operating parameters. If
you select No, the SLS uses the “switch settings” and the
analysis function that you select in the Switch Settings
section of the Contiguration Screen.
Note: This question applies only to the functions and
parameters that the DIP switches can select, not to the
setpoint or other settings, which have their own Yes/No
options.
Switch Settings and Function Selection
Note: If you answered Yes to the preceding question, you
can bypass this section of the Configuration Screen.
This section enables you to select the SLS analysis function
and operating parameters for the current configuration
record. (For a complete description of these settings, refer
to Chapters 2 and 5 of the SLS User’s Manual, Catalog No.
280~NDool.)
Use the SPACE BAR to toggle each switch setting field to
either Off or On. “Off’ selects the parameter in the left
column, while “On” selects the parameter in the right
column. Note that the arrow points left for “Off’ and right
for “On.”
Set these “switches” according to the requirements of your
application.
The SLS Function field selects the SLS analysis function.
When you highlight this field, the SLS Function Selection
Menu appears on the screen, as shown in Figure 5.3 on
page 5-8.
5-7