User`s manual

-
Figure 4.9 Menu After Pressing the Down Arrow Key Twice
Targeting Light On
Setup / Teach Node
Strobe Lighting
Output Normally Closed
Press the ENTER key.
This selects the “Object Void Measurement” function, and
it now appears in the SLS Function field, as shown in
Figure 4.10.
Figure 4.10 Menu After Pressing the ENTER Key
1-D Spat ia 1 Measurement
Object Width Heasurment
Object Uoid Neasuxment
Targeting Light On
Setup / Teach Mode
Largest Object Width
I-D Object Recognition
Strobe Lighting
Output Normally Closed
Press the ESC tiy, then This returns to the Main Menu (Figure 4.1, page 4-3) and
press the ENTER key.
saves the “Object Void Measurement” function
-
This completes the keyboard familiarization procedure.
You have seen how all of the keys work, except for the F3
key and right arrow key. The F3 key selects a calibration
function that is active only when you configure specific
SPC parameters. Chapter 8, Stafistical Process Control
Option, demonstrates using the F3 key to select the
calibration function. The left and right arrow keys are also
demonstrated there.
4-9