User`s manual

Figure 4.4 Fi Key: String !3earch Function
hart Linear Sensor
klP
Version 2.88
-
I
Use PgUp, PgDn, Hone, End, 1, and t to uiw. Fl to search. ESC uhen done.
I
Ccmf igure
Ihe tern “Configure” means setting up the SLS for a specific
application. It includes selecting and storing inspection function
parameters, setpaints, and data accumulated while operating in the
“setup&ach” mode,
If you had typed “monitor,” the software would search for
the first occurrence of that string.
Note: The case of the string has no effect on the search.
Thus, MONITOR, Monitor, and monitor are all the same to
the search function.
Press the ESC key.
Press the F2 key.
This returns to the Main Menu (Figure 4.1, page 4-3).
When you press F2, a message appears asking you to
“Enter a new port number (ESC to cancel):” Below the
message is the current default COM port number.
If you enter 2 (then press ENTER), and COM 2 is not
installed in your PC, this message appears: “The specified
communication port number does not exist. The hardware
does not show the presence of COM2.”
Press the F4 key
When you press F4, this informative message appears:
SLS is connected to COMl.
Series B, Revision A.
Press any key.
-
This message shows you quickly the default COM port
number and the series and revision levels of the firmware in
the SIS connected to that port.
-
Verify that the Configure
This selects the Configuration Menu, the upper part of
option i.~ highlighted in the
Main Menu, then Press the
which appears in Figure 4.5 on page 4-7. Note that the
ENTER key.
prompt line has moved to the bottom of the screen, and the
former prompt line now conkns the Con&u&on Menu
options.
4-6