User`s manual

Figure 4.3 Fl Key: Displaying the Main Menu Help Message
iDMrt Linear Sensor
Help
Version 2.00
Use PgUp, PgDn, Hone, End, 1, and t to uiew. Fl to search. ESC uhen done.
I
The tlain Iienu lists the main options in the SLS Configuration Support
Software.
To highlight an option in the renu, use the Up Armu t and Dow clrrou 1
keys (or the option’s initial letter) to lwue the reverse video bar
(“cursor”) over the desired option.
Use the ENTER key to select the
high1 ighted option.
To print the contents of the current menu or help message, press the Print
Screen key or the Ctrl and P keys,
These are the kin Menu options:
Conf igure
The tern “Configure” means setting up the SLS for a specific
application. It includes selecting and storing inspection function
parameters, setpoints, and data accumulated while operating in the
‘rem the Home key.
The help message scrolls back up to the first page.
Press and release the &
arrow key.
Press and release the Q
arrow key.
The help message scrolls down one line. (If you press and
hold the down key, the page scrolls continuously.)
The help message scrolls up one line.
Press the FI key again.
A message appears asking you to “Enter a string to look up
(ESC to cancel):” Below the message is the word
“Configure,” which is the default “string,” in this case.
-
Press the ENTER key.
This causes the CSS to search for the fmt occurrence of the
string “Configure.” When found, Configure appears on the
top line in the message box, as shown in Figure 4.4 on page
4-6.
4-5