User`s manual

-
Press the ENTER key to
When you press the ENTER key, the Configuration Screen
select the Add option.
appears on the screen, as shown in Figure 3.4.
-
Fgure 3.4 Configuration Screen
Smart Linear Sensor
Configuration Screen
Version Z.BB
Fill in the configuration screen. Press ESC uhen done. Fl for help.
Use hardmare witch settings? Yes
-(Off) Pitch Settings-
Targeting Light Off Off x--
Targeting Light On
Off x--
Setup 1 Teach Mode
Output Normally Open Off <-- Output Normally Closed
1-D Spatial Neasurement
Send Setpoint values to the Smart Linear Sensor? Yes
Set Point A (B - 188) 188.88
Set Point B (B - lBB1 lBB.BB
Type “Locate Edges” in the
highlighted Description
field, then press the ENTER
key.
“Locate Edges” is the name or description of the new
configuration record in this example.
When you press the ENTER key, the cursor advances to the
“Use hardware switch setting?” field, as shown in
Figure 3.5 on page 3-6.
3-5