User`s manual

Figure 3.1
Aiming Target Orlentatton Relative to the SLS
Inspection direction
Type in “SLS,” then press
This initializes the CSS. After a few seconds, the powerup
the ENTER key.
banner appears on the display, as follows:
ALLEN-BRADLEY COMPANY OPERATOR INTERFACE AND LOGIC DIVISION
4
I
CONFIGURATION SUPPORT SOFTWARE - SERIES B, REVISION A
This support software was created by the Allen-Bradley Company,
I
Operator Interface and Logic Division. It is intended for use
:
with the Allen-Bradley Smart Linear Sensor (Series A and B).
4
t
Copyright (C) 1990, 1991, Allen-Bradley Company - Operator
t
Interface and Logic Division, Milwaukee, Wisconsin - U.S.A.
I
4
Press any ky.
Note: The terms “SERIES B, REVISION A” and “(Series
A and B)” in the banner message refer to the status of the
firmware in the SLS. The term “Version 2.0” at the top of
the display refers to the status of the Configuration Support
Somare.
The Main Menu appears on the screen, as shown in
Figure 3.2 on page 3-3.
32