User`s manual

Staging the SLS and
Initializing the CSS
Your Action
Find the bar pattern
labeled “Aiming Target” in
the back of this manual.
Orient the bar pattern so
that ‘Aiming TaTget” is
positioned as shown in
Figure 3.1.
Use the targeting light to
align the target as shown in
the figure.
Verify that the Remote
- Configuration switch on the
SLS is set b “Enable.”
Power up the PC, then type
“CD\sLs” to change to the
SLS directory.
Getting Started
This chapter provides a quick, hands-on introduction to the
main features of the SLS Configuration Support Software
(CSS). Included is a set of “Getting Started” procedures for
preparing an example SLS configuration record, sending it
to the SLS, and looking at the View Image, Monitor, and
WC display options while the SLS operates using the
example configuration.
Before proceeding with this chapter, perform the hardware
. connection and powerup check procedures if you have not
already done so. These are described in Chapter 3 of the
SLS User’s Manual, Catalog No. 2804-NDOOl. Then,
perform the SLS setup procedures described in the Staging
SLS and Focusing and Aiming SLS sections in Chapter 4 of
that manual.
Use the following procedures to stage the SLS and initialize
the CSS.
Comments
Refer to Figure 3.1 on page 3-2.
The targeting light should lie across the bar pattern as
shown in Figure 3.1. (The targeting light coincides with the
SLS field of view.)
If necessary, refer to Chapter 2 in this manual, Setting
Remote Configuration Switch.