User`s manual

Setting the Remote Configuration Switch

The Remote Configuration switch on the SLS must be set

to “Enable” so that the SLS can communicate with the PC

and CSS.

Use the following steps to set the switch to Enable.

Your Action

Comments

Loosen thefour screws on Be certain that the screws remain in the cover.

the SLS cover plate.

Carefilly remove the cover

plate from the SLS, ami set

Use the screwdriver supplied with the 3.X The SLS

it aside for future use.

appears as shown in Figure 2.2 with the cover removed.

Fgure 29 Setting the Remote Configuration Switch

STROBE LIGHTING

NORMAL LIGHTING 0 STROBE LIGHTING NORMAL LIGHTING -

REMOTE CONF. ENABLE REMOTE CONF. ENABLE

REMOTE CONF. DISABLE

OUTPUTS N.C.

REMOTE CONF. DISABLE

Press down here Press down here

(0) to set switch (0) to set switch -

I I I I

2-4