User`s manual

Software Package:
Items Included
Hardware
Requirements
Installation
Installing the SLS Configuration Support Software (CSS)
includes two main tasks: connecting the SLS to a suitably
equipped personal computer (PC), and installing the CSS in
the PC.
In addition to this manual, you should find the following
items in the CSS package:
l The SLS Configuration Support Software is supplied on
two 5.2~inch diskettes and one 3%inch diskette. L.ook
for these diskettes in the plastic holders at the back of
this manual.
l One 12-foot (3.7m) RS-232 communication cable,
Catalog No. 2804-CSC1, which connects the SLS to a
serial communication port on your PC. (If you intend to
connect more than one SLS to your PC, you need one
cable for each additional SLS.)
l One package of connector pins, which you can use to
modify the 2804-CSCl cable for use with an
Allen-Bradley 1784-T45 Industrial Terminal.
l One 9-t+25 pin adapter, which connects the 2spin
connector on the 28O&CSCl cable to a 9-pin se&l port
on an IBM-AT or comuatible PC. U’his adaoter is not
required for an IBM-&, IBM-XT; or compatible, PC.)
Verify that these items are included in your package.
You can install and operate the SLS Configuration Support
Software in any IBM-PCTM or compatible personal
computer with the following minimum equipment:
l DOS: Version 2.1 or higher.
l RAM: 64OK bytes, with 520K bytes free.
l Disk drives: Two 1.2M-byte, 5.2~inch disk drives, or
one 1.44M-byte, 3.S-iich disk drive.
l Serial communication ports: One port for each SL.S
connected to the PC.
l Communication cables: One RS-232 cable for each
SLS attached to the PC, and one cable for a printer, if
used.