User`s manual

-
Long SPC Setup
Method
Your Action
Return to the Main Menu, if
you have not already done
SO.
Press the “s” key to
highlight the Statistical
-
Process Control option,
then press the ENTER key.
Press the “L” key m
highlight the Long SPC
Setup Menu option, then
press the ENTER key.
--
Select the Add option.
The long SPC setup and operation method enables you to
specify all of the SPC parameters that are available in the
CSS. then run SPC operations using that record. Before
using this option, you should have a full knowledge of SPC
concepts and parameters.
Using the Long SPC Setup Method
Here is the procedure for using the long method of SPC
setup and operation:
Comments
When you press ENTER, the SPC Setup Menu should
appear on the display, as shown in Figure 8.3 (page 8-10).
(If the SPC Setup Menu does not appear, it was not selected
as the default setup menu in the Program Configuration
Screen. If this is the case, refer to Chapter 9. Program
Conjiguration Option, for information about selecting the
SPC Setup Menu as the default setup menu.)
When you press ENTER, the Long SPC Setup Menu
appears on the display, as shown in Figure 8.9 on page
8-26.
Note that the Add option is highlighted when the Long SPC
Setup Menu appears on the display without existing setup
records. Otherwise, the SPC option is highlighted.
At this point, you must create a new setup record before
you can perform SPC operations. The setup record that you
create should correspond to the configuration currently
operating in the SLS.
When you press the ENTER key, the cursor moves to the
Description field in the setup menu.
Enter 1 to 50 characters. Enter a descriptive name
for the SPC setup record.
8-25