User`s manual

centimeters. For more information about the F3 calibrate
function, refer to Calibration, Chart Scaling, and SLS
Scaling on page 8-46.
F$J4llly SPC setup
Th
e run-only SPC setup and operation method enables you
to perform SPC operations by selecting an existing SPC
setup record. Thus, you need little or no experience with
statistical process control to use this setup option.
Using the Run-Only SPC Setup Method
Here is the procedure for using the run-only method of
SPC setup and operation:
Your Action
Return to the Main Menu, if
you have not already done-
SO.
Comments
Press the ‘3” key to
highlight the Statistical
Process Control option,
then press the ENTER key.
Press the ‘3” key again to
highlight the Short SPC
Menu (RUN Only) option,
then press the ENTER key.
When you press ENTER, the SPC Setup Menu should
appear on the display, as shown in Figure 8.3 (page 8-10).
(If the SPC Setup Menu does not appear, it was not selected
as the defaull setup menu in the Program Configuration
Screen. If this is the case, refer to Chapter 9, Program
Configuration Option, for information about selecting the
SPC Setup Menu as the default setup menu.)
When you press ENTER, the run-only version of the Short
SPC Setup Menu appears on the display (along with three
example setup records). Refer to Figure 8.5 on page 8-15.
Note that the SPC option is always highlighted when the
Short SPC Setup Menu first appears on the display.
Note also that the first example setup record, “Width
Measurements,” is highlighted. (All three of these setup
records were prepared earlier by someone using either the
short or long SPC setup menu.)
You can highlight any of the other setup records by using
the up and down arrow keys, the PgDn and PgUp keys, and
the Home and End keys.
Note: The setup record that you select must correspond to
the configuration currently operating in the SLS. Ifyou
need to change the SLS configuration, go to the
8-14