User`s manual

This screen contains several data entry fields, which are
described as follows:
Import File Name - The default file name,
\MSXXSJMPTXT, appears the fust time you use this
function. You can use this file name, or enter a file name of
your choice. This is a requited entry.
Use Automatic Datdime? - Select Yes if you want the
MetriStat program to enter the date and time for each
subgroup, or select No if you want the ach& dates and
times to be used.
The message “SLS on COMl,” which follows the data/time
field, indicates the communication port to which the SLS is
connected.
Part ID - A part identification must contain at least one
character, but not more than 12 characters. This is a
required entry.
Characteristic ID - A characteristic identification is a
name that describes the inspection results at each of the
analog outputs. The name must contain at least one, but not
more than 10 characters. One characteristic ID is required;
however, if you omit the other ID, the correspondiig results
information will not be imported into the MetriStat Lab
system.
Sample Size (OPS) - The sample size is the number of
observations per subgroup (OPS). It is the number of
individual inspection results, from 1 to 99, that you want in
each subgroup. The default value is 1. This is a required
entry for result A and result B, whether or not you intend to
import them both.
Machine, Operator, Your Key - You can use these fields
to further identify the source of the samples; however, they
am not required entries.
Base, Multiplier - You can use these two fields to convert
inspection results frompercen&zge values (0 to 100%) to
measurement values (inches, centimeters, and so on). The
conversion calculation uses the Base and Multiplier values
in this formula: ((Result * Multiplier) + Base).
When you complete the data entry fields, press the ESC key
to exit the setup screen. To save the entries and start the
conversion, verify that the “Save” option is highlighted,
then press the ENTER key.
7-11